JOB FUNCTIONS:

• 1. Responsible for Assembly, Labeling and Packaging of Product, i.e. door panels
• 2. Placing components on to machine.
• 3. Pack parts in proper box, cage, crates or racks.
• 4. Sewing using precision on industrial sewing machine.
• 5. Using staple gun with precision.
• 6. Removing parts from edge wrapper.
• 7. Gluing and assembling parts.
• 8. Hand welding.
• 9. Occasional light sweeping with regular broom within the work cell.
• 10. May rotate between cells during the shift.
• 11. Inspecting and Reworking assembled component.
• 12. Must be able and willing to work daily and weekend overtime.

Physical Requirements of Job:

Standing except during breaks.

Lifting maximum of 35 - 50 lbs.

Pull and push racks with components up to 30 feet.

Bending at the waist is occasional.

Rubber ergonomic floor mats are available.

Breaks: two 10-minute breaks; one 20-minute break. Work 2-3.5 hours between breaks.

Walking only to and from breaks and/within work cell

Internal temperature of plant varies with season –heating source/fans during cold weather; fans located at all workstations during warm weather.

Small fine motor skills utilized.

Pace is constant but not fast

Physical Requirements of Job:

Standing except during breaks.

Lifting maximum of 35 lbs.

Bending at the waist is occasional.

Rubber ergonomic floor mats are available.

Breaks: two 10-minute breaks; one 20-minute break. Work 2-3.5 hours between breaks.

Internal temperature of plant varies with season –heating source/fans during cold weather; fans located at all workstations during warm weather.

Small fine motor skills utilized.

Essential Functions:

• 1. Remove parts from the mold – by opening a gate to remove the mold or the mold drops down onto surface
• 2. Trim excess flash and gates from parts – using clippers
• 3. Inspect parts for defects.
• 4. Pack/unpack parts into/from close by box or cage, by bending down into large crate to place completed piece or taking parts from containers at floor level to table height.
• 5. Place labels on boxes.
• 6. Maintain a clean working environment.
• 7. Place clips onto molded parts (these parts are unpacked from boxes at floor level)
• 8. Push filled containers on level ground to outside of work area approximately 20 feet away.
• 9. Adhere to applicable quality and environmental system requirements, work instructions, and procedures.