This position reports directly to the Process Engineering Supervisor and is responsible for the general and specific job duties of IAC as described below:

General Job Duties:

• To exhibit teamwork skills and actively participate in team activities in a positive working environment.
• To demonstrate problem solving skills in a work environment that is striving for continuous improvement.
• Follow Company policies and display conduct expected of IAC employees as described in the Work Plant Rules and Work Safety Rules.
• Adhere to all safety and health objectives, policies and procedures of IAC to provide for a safe and healthful workplace. Work in a safe manner at all times and report any unsafe conditions to your supervisor in order that the situation can be corrected. Report all accidents and near misses in a timely manner when they occur.
• Maintain proper ergonomics at all times when performing assigned tasks.
• To perform daily cross-functional job assignments in all areas of your assigned department per the established procedures and work guidance.
• Participate and support all lean, continuous improvement programs, initiatives and activities.
• Clean all assigned work areas after completion of the required work according to 5s standards.
• Maintain proper radio etiquette when using company radios, PA System and/or phone, business use only.
• Maintain professionalism when representing the company.
• Perform other duties as assigned.

Specific Job Duties:

• Maintain all injection mold tooling

• Organize all internal and external tooling repairs

• Review all new tooling to meet company tooling standards

• Review and approve mold flow analysis on new tooling

• Review tooling designs to ensure IAC standard cycle time

• Process development on all new tooling

• Troubleshooting on current molding processes

• Ensure all critical product design issues are identified and resolved

• Optimize mold design, manufacturability, and process capabilities

Experience Requirements

• Minimum of (3) three years' experience in manufacturing engineering.
• Experience with urethane and robotics is preferred.
• Through understanding of injection molding processes
• Excellent computer and communication skills
• Excellent problem solving and troubleshooting capabilities
• Ability to pay attention to detail

Training Requirements

• This position will be required to travel to other facilities or training locations as well as on-site training as needed.

PPE Requirements

• This position requires the use of eye protection and hearing protection and any PPE specific to the task being performed.

Physical Demands

• Must be able to stand on feet 8-12 hours a day and lift up to 75lbs on an occasional basis and 40 lbs on a regular basis. Must be able to perform overhead work as well as work below the waist.